Thank you for your reply.
Motor is sensorless.
I have BOOSTXL-DRV8305EVM but which MCU should I Use like TMS320F28027F or TMS320F28069?
Also while selecting BOOSTXL or MCU which factors I need to consider?
Also I am herewith attaching pdf in which…
Part Number: LAUNCHXL-F28069M Other Parts Discussed in Thread: CCSTUDIO I am trying to spin a motor with a TI Booster Pack DRV8305EVM. Is there a version of this /cfs-file/__key/communityserver-discussions-components-files/171/qsg_5F00_gui_5F00_universal…
Patrick,
I'd say about 25% of the posts on here are on this topic. I know it's hard ro read through them all, but there is a lot of good information archived on this forum.
You should read this blog post.
There is also a QSG that accidently got…
Hi James,
Thanks for your reply. Is it possible to use this Kentec QVGA Display BoosterPack with the chosen MSP430F6736?
Our product does not require extensive use of graphics. It is used only to display certain information at periodic intervals…
1. We can do a schematic review. Did you attach the schematic in your question? I do not see it attached.
2. It is not mandatory to complete programming through Arrow's Programming Services. TPS65218D0 can be re-programmed before PCB assembly, using…
Hi Aaron Barrera,
I'm following the same schematic of ' LAUNCHXL-F28069M ' and ' BOOSTXL-DRV8301 Rev.B'. I've combined both into one board and running 'proj_lab13b'. It works fine with original launchpad+booster card setup and not in my board. All these…
Thanks.So the datasheet showed below may have some problem in the setting of the filter frequency of the voltage sensing. And further more,the USER_VOLTAGE_FILTER_POLE_Hz should be same with the RC filter cutoff frequency?!
High-Speed Sensorless-FOC…
Anton,
Anton Karlsson said: Is this just a matter of fiddling with the controller parameters or is there something else I can look into?
there are several things to think about
yes, tuning the speed regulators is certainly critical, and will often…
your Ls values are incorrect. The smallest real value would be a few uH
this would be for very high speed motors.
if you have one of these types of motor use proj_lab02c to identify (even just use your DRV8312 kit to make sure you get the right values…
attached QSG was accidently left out of MotorWare release, it belongs here
C:\ti\motorware\motorware_1_01_00_13\docs\guis\universal
there is also the QSGs for the "frozen" GUIs
C:\ti\motorware\motorware_1_01_00_13\docs\guis\hvkits_8312s_8301s
…
