Part Number: UCC28950 Other Parts Discussed in Thread: UCC28951 , TINA-TI Hello,
I am working on a design of 2kW DC-DC converter where the input is 380-400V DC and the required output is 150V. For this I would like to use UCC28950 Full Bridge Synchronous…
Aziz,
The DSK5510 is a very old device and support is very limited as a result. However, I was able to find some information that might assist.
Please find 3 documents attached for C5510. The TMS320C55x DSP Peripherals Overview Reference Guide, chapter…
6813.KCU105 HSDC Pro User's Guide.pdf Isabel,
Can you try a test using your settings and follow the Vivado loading instructions in the attached users guide to verify your setup is working properly using our HSDC Pro GUI. This comes up just fine with…
Hello Vandana,
I did some quick check and added my comments to the schematics.
Please review and update the comments.
General Notes (For customer to review)
8512.hinduja_cluster_mpu_board_v1.2.pdf
Regards,
Sreenivasa
Hi,
The thread APIs are supported as part of POSIX API support from SYS BIOS.
XDCtools provides the underlying core tooling needed by TI-RTOS and its components, including SYS/BIOS. You must have both XDCtools and SYS/BIOS installed in order to use…
Hi Akihisa，
1. 15V/2A,3A is too large power for LM25184. In my opinion, customer should consider a flyback controller.
2. You can send the attached calculation tool to your customer. They can learn more insight principles if they are interested. …
Part Number: PHYTC-3P-PHYCORE-AM335X Hello,
We have two devices based on PHYCORE-AM335X and are using Ti Linux kernel V4.4.62 on one and V5.10.65 on other.
We have a software application to create and write CSV file on USB devices using fopen,fread…
Part Number: TLV320AIC3109-Q1 Hello
I am using TLV320AIC3109-Q1 in my system and while reading datasheet I have found some mistakes in datasheet.
In datasheet register map table (Table 8. TLV320AIC3109-Q1 Register Map) and its detail are not same…
Hi Dave,
Yes, the high freq caps (1nF) are needed as shown in the EVM. They must be placed within 1mm of IC. Your decoupling caps C22, C8 and C27 (1uF) has very long ground trace which decreases the their effectiveness due to the trace parasitic inductance…
Hi Jitendra,
Thank you for the query on UCC28600.
I think the overall schematic looks fine.
I have attached the calculator also where you might need to slightly adjust the Rovp1 and Rovp2 resistors.
3857.slvc104j.xls
Ensure that the capacitor…
