Part Number: AM625 Other Parts Discussed in Thread: AM623 , , , AM620-Q1 , SYSCONFIG , SK-AM62B-P1 , SK-AM62-LP , SK-AM62B , SK-AM62-SIP , AM62D-Q1 , AM62X-PET-CALC
Hi TI Experts,
I am starting a new project and want to use Sitara AM62x processor…
Part Number: AM625SIP Tool/software: th board :AM62X SIP SKEVM PROC162E1
It ran well at the beginning. But one day it suddenly couldn't boot from spi flash. I boot from the uart and sf probe the flash. It report the error " failed to initialize the…
Other Parts Discussed in Thread: SK-AM62B-P1 , SK-AM62-LP , AM625SIP , SK-AM62-SIP Tool/software: Is it recommended that a ferrite be used for each of the SoC supply rails listed below?
VDDS_OSC0 VDDA_TEMP0 VDDA_TEMP1
I checked the SK-AM62B-P1 and…
Part Number: AM625SIP Other Parts Discussed in Thread: AM625 , Tool/software: Hi,
We are looking support for BSP development towards AM62x Sitara Processors TSN development.
Can I get info about 802.1 CB standard support and do we need to load AXE…
Part Number: AM625SIP Tool/software: Hi TI!
The AM525SIP (or similar) Multimedia controller supports RGB 12-, 16-, 18-, and 24-Bit Active Panel Interface Support (Replicated or Dithered Encoded Pixel Values)?
Thanks very much
HI Board Designers,
FYI on OLDI0 or DPI (VOU0) resolution
AM625 : minimum resolution on DPI and OLDI?
e2e.ti.com/.../am625-dss-pixel-clock-can-t-set-less-than-15937500-hz
Requested pixel clock should be greater than 7MHz, is what we are setting…
Part Number: AM625SIP Other Parts Discussed in Thread: LP-MSPM0L1306 , AM625 Tool/software: Hi Nick
My customer would like to evaluate MSPM0 ADC along with AM625-SIP.
Could you please check the interface what they did initially?
AM625SIP-MSPM0 IF…
Part Number: AM625SIP Other Parts Discussed in Thread: SK-AM62-SIP Hi
May I have a question about AM625SIP's DDR_ZQ pin?
I think DDR_ZQ must connect to VDDS_MEM_1P1(1.1V) though 240ohm registance.
・In AM625SIP DS
・In ISSI LPDDR4 DS
However…
Part Number: AM623 Other Parts Discussed in Thread: AM625
Tool/software:
Usually add RC filter on RESET signal to anti noise, but the slew rate requirement of RESET signal on AM62x datasheet is quite sharp, on customer board it is about 10V-100V/ms…
Part Number: AM625SIP Other Parts Discussed in Thread: AM625 , , SK-AM62-LP Tool/software: Dear TI
I am trying to load the T Eye tool on to one of the Cortex A53 cores, but I always get the following error message:
CortexA53_0: File Loader: Verification…