Search tips
Showing 288 results View by: Thread Post Sort by
    Answered

  • SK-AM62-SIP: DDR CONFIG

    Resolved
    Part Number: SK-AM62-SIP Tool/software: Hi https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1446740/am625sip-sysconfig-ddr-subsystem-ddr-component-js-validation-failed?tisearch=e2e-sitesearch&keymatch=AM625SIP%2520DDR# For…
    • Resolved
    • Answered

  • AM620-Q1: AM620-Q1 Unused interface termination

    Resolved
    Part Number: AM620-Q1 Other Parts Discussed in Thread: AM625-Q1 , AM625 , AM623 , AM625SIP Hi TI Team, We are doing the Custmize design with AM620-Q1 processor. For our Application we are not using the following interface like JTAG , MCU Section…
    • Resolved

  • AM625: Question about booting from SD card

    Answer Suggested
    Part Number: AM625 Tool/software: Posting on behalf of Sascha Hauer I have a question regarding booting a AM625SIP from SD card in filesystem mode. I have a binary disk image which boots fine from SD card. However, the same bootloader binary doesn…
    • Answered

  • AM2431: CRA Support and VPP Pin Handling

    Resolved
    Part Number: AM2431 Hi experts, Can you tell me if a VPP pin is required to support CRA? If it is not possible to determine this, we will design it with the possibility of using a VPP pin in mind, as stated in the following thread. Normally, we operate…
    • Resolved

  • AM623: 0.8mm Pitch Package Options for AM62xx Series

    Part Number: AM623 Other Parts Discussed in Thread: AM625-Q1 , AM625 , , AM620-Q1 , AM625SIP , AM62D-Q1 Hello Team, Hi, I would like to confirm the package options available within the AM62xx family. We are currently evaluating AM6232 for our design…
    • Answered

  • RE: AM3351: Current or impedance specification for VBUS analog input pin

    Resolved
    Hello Tom FYI, in case this helps. [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP / AM62L : Custom board hardware design – USB2.0 interface look for Inputs related to implementing isolated USB interface Regards, Sreenivasa
    • Answered

  • RE: AM623: Stuck in Reset

    Resolved
    Hello Justin, Listed below are Recommended References for review and design of custom board AM62X TI.com product page www.ti.com/.../AM625 www.ti.com/.../AM623 www.ti.com/.../AM620-Q1 www.ti.com/.../AM625-Q1 Collaterals AM62x Sitara Processors datasheet…

  • TPS65219: PMIC having a strange behaviour of buck3 during power-up

    Part Number: TPS65219 Other Parts Discussed in Thread: AM625SIP , AM625 Tool/software: Having a PCB with a TPS6521902 supplying a AM652SIP thus having the recommended set-up. Monitoring buck1 (blue), buck2(red), buck3(green and INT pin (yellow) I see…

  • RE: AM625: Boot mode buffers

    Hello Prema, Make sure you use the below available design collaterals to perform a self-review (focus on the collaterals in bold) before sharing the schematics. Recommended References for review and design of custom board AM62X TI.com product page…

  • RE: AM62A7-Q1: DSS: Lower emissions when using 10 bit video output

    Hi Hi Bas Vermeulen, You can start with this FAQ: (+) [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP Custom board hardware design – Display Parallel Interface (DPI) 24-bit RGB- display interface - Processors forum - Processors - TI E2E support…

Didn't find what you are looking for? Post a new question.