Hi Steven, Thank you for your reply. Here's the Rev D slus270d.pdf Kindly see below the snippets.. Furthermore, I've checked the SLUS270F, it seems that the "line regulation" for the UCC380x is not copied on SLUS270G. Can you please help confirm? Thank…
Hi Nick,
Sorry for open this thread again.
We tried the default key again to unseal CPE, and SBS configurations all turned to 00 from SEALED, then we tried to change the CPE value to 01, but still 00. Do you know why we cannot write the value? Have…
Hi Koichiro-San,
I think you might be referring to a different version of the ICD which might not be completely applicable for AWR1843. You can use the below version.
5758.mmWave-Radar-Interface-Control.pdf
Koichiro Tashiro said: Q1) According…
Part Number: BQ40Z50-R1
There is something about the BQ40 behavior that I don't find intuitive after thoroughly reading the datasheet and technical manual.
In section 5.2. of technical manual( link )
"In NORMAL mode, the device takes voltage,…
Part Number: BQ20Z655 HI,
I entered SBS commend 0x61( FullAccessKey) with FFFF FFFF 2word value to make full access mode.
And tied to change operation Cfg A,B,C register
I read these register value and typed new value in data flash menu on EVSW…
Hello Rom, A full reset will: - check for failures - initialize all sbs values - it'll keep same load mode/select. If not autodetected, it will assume LOAD_CONSTANT_CURRENT = 0 and LOAD_CONSTANT_POWER = 1 - it'll copy Flash data into RAM - it'll read…
Hello Miguel, thank you for your reply When we communicate with BQ Studio using EV2400, we are able to see the data even during discharging. This means we are able to communicate with the gauge while discharging. If the gauge is not acknowledging the…
This phenomenon occurs on some boards, causing a sudden link down during normal operation, leading to chip failure.
I've attached the TVS and line filter specifications. Will this be a problem with the specifications? Nichtek_D3271-3R0AKXB_V.3_20190610…
Part Number: BQSTUDIO Other Parts Discussed in Thread: BQ40Z80 Hi,
I've noticed an issue in bq Studio (1.3.101), which occurs when a pack is configured to report remaining and Full capacity in Wh (as opposed to mAh). Whilst the Hex value received is…
