Other Parts Discussed in Thread: BQ27510-G3 , BQSTUDIO Hi all,
In one of our designs, we are using the fuel gauge BQ27510-G3.
We have successfully completed the optimization cycle of this fuel gauge using BqStudio software and generated the golden…
Hi Chris ,
This is my user.h .
#ifndef _USER_H_
#define _USER_H_
/* --COPYRIGHT--,BSD
* Copyright (c) 2012, Texas Instruments Incorporated
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
…
Part Number: UCC256302 APOLOGIZE FOR NOT GETTING THE CORRECT PART NUMBER!.
It seems that the Integrated magnetics proposed in the attached paper, expression of Lm (Lo?) equation (8) in the paper is not exactly correct. The set of values obtained do…
Hi Corey
That behavior isn't due to the ADC itself. This has definitely been verified during design and validation of the device. I ran a quick test on an EVM today and captured the following data in JMODE17 with ramp test mode.
ADC12DJ3200EVM_JMODE17_RampTest_Scr0_TDPlotExport…
Other Parts Discussed in Thread: DRV8301 Hi. I'm trying to identify the motor with the GUI Composer Instaspin Foc. The motor acts wierd; changing directions, vibrating and making sounds. I tried to go through the instaspin lab: 1a and 2a, but when I ran…
Part Number: EK-TM4C1294XL Tool/software: Code Composer Studio Hello, I am trying to test code from TI 'simple_tx' for can bus communication with my EK-TM4C1294XL board.
All I want to see is just simple signal with information from can TX pin before…
Other Parts Discussed in Thread: TM4C123GH6PGE Hello, I'm using tiva c series TM4C123GH6PGE uC, and i have interfaced 4Mb of Numonyx flash memory to it in parallel manner, the problem is i'm not able to read and write data from it, is there any tutorial…
Other Parts Discussed in Thread: TM4C123GH6PGE I have a Tiva C series TM4C123GH6PGE uC, where i have interfaced 4Mb external flash memory to the uC. I'm trying to write the data onto the flash memory as mentioned in its datasheet as pulling the chip and…
Hello, Bryan,
I'm using ADS124S08 as the ADC. Sorry for the confusion.
Let me explain it from the beginning then. The min-max output value of the thermopile is between 0.134 mV and 178 mV.
I need to increase this mV value to the ADC reading range…
