Part Number: TCAN1042HGV-Q1 Other Parts Discussed in Thread: TCAN1042HGV Hi Team,
There is a good new that we could DIN TCAN1042HGV!
The customer uses TI transceiver and the CAN_H CAN_L signal is abnormal. This in turn causes the occurrence of error…
Hi Norbert,
As VCC powers up, the CANH/CANL leakage will be very low <4.8 uA for VCC voltages ranging from 0 V to about 0.6 V. Above that, there will be an increase in leakage (typically within 5~20 uA) as the VCC ramps up to its minimum value (UVVCC…
Part Number: TCAN1042HGV-Q1 Hello TI experts,
my customer wants to know that TCAN1042HGVDQ1 support SAE J1939 standard.
(both HW and SW)
Could you check it?
If it does not support, please recommend a part which can support this standard.
Best…
Part Number: TCAN1042HGV Hi Expert,
We found the customer design is putting a 30k ohm on STB pin.
Pls advice any concern or side effect. Will it impact the slew rate?
Thanks
Eric
Part Number: TCAN1042HGV Hi Expert,
Would like to apply the TCAN1042 for low frequency communication
Conditions:
--Every 5ms will transfer a pulse through the TCAN1042
--No defining of the pulse length
Since this applicant is working well…
Part Number: TCAN1042HGV-Q1 Dear Team,
I am using TCAN1042HGVDRQ1 part in one of my design, I am interfacing TCAN1042HGVDRQ1 to i.mx8 processor.
As per the TCAN1042HGVDRQ1 datasheet it is given that "All Devices Support Classic CAN and 2 Mbps CAN…
Part Number: TCAN1042HGV-Q1 Hi team,
My customer would like to know what is its endurance time if VBUS voltage is above 58V (this is ABS max voltage rating)
Do we have this kind of data?
Thanks
Part Number: TCAN1042HGV Dear,
We find some question about TCAN1042HGV , IF Vcc dely to VIO 100ms will be shunt down.
below as schematic:
If any suggestion, Please advise me.
Thanks,
Best regards,
Tom
