Part Number: TUSB321 Other Parts Discussed in Thread: TIDA-01243 , USB-CTM-MINIDK-EVM , TPS25910 In one our design, we are using TUSB321 and HDSS3212 to design a DFP USB Type C port with a standard USB 3.0 port as the source. Our schematic is very similar…
Part Number: TPS65986 Hello,
This question relates to our TPS6598x devices, particular in a system similar to our mini-dock reference design: TIDA-01243
The section of the design I am curious about is the power path from USB-C UFP (port where the board…
Hello Mark,
The TPS65983B is only for use with Intel Thunderbolt reference designs and is constrained to meet the requirements of those designs.
An important difference in the TPS65987D is support for two 5V to 20V, 5A bidirectional switches to VBUS…
Hi Kevin,
It would be the same as an TPS65982 dual port system with a single flash.
You can check the TIDA 01243 dock design for reference.
www.ti.com/.../tida-01243
Jacob
Hello Igor, No, the TUSB8044 is an standard USB Hub and as defined by the USB Type-C specification: "USB hub ports shall not implement or pass-through Alternate or Accessory Modes." We do have a reference design for an "Alternate mode expander…
Hi Guy,
To convert DP to HDMI, you would need to use an active converter chip. We have a reference design that uses the MCDP2850-BB for this function. Please refer to it at the link below:
www.ti.com/.../TIDA-01243
Thank you,
Eric
Hi Jeff,
thanks a lot! Will try to check it right now.
Thanks for comment about USB 3.0 P/N swapping. It was done at TI board that we have - EVK TIDA-01243 ;) And than i found that USB 3.0 standard allows to swap P/N signals (only between the pair RX…