Other Parts Discussed in Thread: CC2500 Hi, I am designing a half duplex wireless ethernet link which provides a transparent LAN interconnection pipe as my university project. I plan to use TLK100 to interface with the ethernet and read the data coming…
Other Parts Discussed in Thread: TLK110
I guess Mr. Ofir Ben-Josef isn't with TI anymore since his email bounces.
Anyway, I'm looking to make an Ethernet extender for use between IP cameras and a switch. I see your dual PHYs that support this…
Test Setup:
TLK100 is set up to transmit/receive 10Mb/s in Full Duplex mode. Ixia was used to generate packets with IPG of 9.6us to test minimum IPG. Packets include 8 preamble bytes (including SFD) and 64 payload bytes. The packets are forwarded to…
Hi all,
In our project, we use TLK100 to replace KSZ8401 Physical Layer Transceiver to build our net device. Connect our device through ethernet switch(TP-LINK) with PC, our device will auto-negotiation to 10M, it can work well and can ping directly…
I'm referencing the TLK100 datasheet (SLLS931B–AUGUST 2009–REVISED DECEMBER 2009) and my question involves the PHYAD[0:4] lines. Page 6/88, Table 2.2 shows MII_COL/PHYAD0 being internally pulled UP by default while all the other PHYAD[1:4] pins are pulled…
Hi,
One of my customer is using TLK100, however they can not set up the link. They think maybe it is due to incorrect configuration of internal register. Could you please provide them an example code to configur TLK100?
Thank you.
HI,
In the application note of the TLK100 , they mention a LAN ethernet HX1188 or H1102 . do you know if we need to implement it ? do you have more information about it ?
thay plan to use a J0011D21BNL *** RJ45 connector . is it ok to use it…
Team,
Is the datasheet info correct on page 46 regarding registers 0x0002 and 0x0003? A customer expected to read out 0x2000 and 0xA201, respectively, but instead read out 0x4000 and 0x5201. All other registers on the board appear to be working perfectly…
I notice in August 2009 on the A revision of the datasheet we added
bullet item " Enables IEEE1588 Time-Stamping", page 1
I had a question from an engineer today looking for a little more clarification on this item. Does our PHY actually provide…
