Part Number: TMDSLCDK138 Hoping this helps someone else. Purchased the LCDK in Dec 2016. Finally trying to use it and found that L line in was shorted to gnd. The connectors (in & out) are in the tall dual connector that is in a metal shield. The rear…
Hi,
Here is the processor SDK Linux Sofdware developers guide:
software-dl.ti.com/.../index.html
Note that this is a guide for the whole SDK, which is supported on various TI SoCs, you need to find the specific device drivers in section 3.3.4…
Part Number: TMDSLCDK138 Hi guys
I am from Vietnam
I have registered an account on TI store with my company account
But I cannot order more than 1pcs for the TMDSLCDK138 board
Do you have the same issue before and any solution for this?
Thanks…
Part Number: TMDSLCDK138 Other Parts Discussed in Thread: OMAP-L138 OMAP-L138/C6748 DEV Kit LCDK layout file question:
The schematic shows that two pins, D4 and D5 of the UPP port, are not brought out to any connector.
I want to look at the layout…
Part Number: TMDSLCDK138 Other Parts Discussed in Thread: MATHLIB , OMAPL138 Tool/software: Code Composer Studio TMDSLCDK138 / CCS7.4
From the DSP, I'm trying to get a 44KHz square wave out on TMP64P3_OUT12. Here's the code I'm trying, what's wrong…
Part Number: TMDSLCDK138 Other Parts Discussed in Thread: OMAPL138 , OMAP-L138 Hi everyone,
I am trying to flash and boot my application program onto LCDK OMAPL138 kit... I followed the procedure from here:
Steps which I followed are:
Connected…
Part Number: TMDSLCDK138 Tool/software: Code Composer Studio CCS 7.4 / TMDSLCDK138 / TMS32-XDS100-V3
My build is stuck at 25% complete. It is "Invoking Command: C:\ti\ccsv7\utils\bin\gmake -k -j 8 all -O"
I thought it might be some sort of file…
Hi Fidel,
I've looked at both the cadence file and the gerber and I find the square thermal pad under the part as expected in both. Below is a capture of the gerber view of the top two layers showing the square thermal pad in the center of the part…
