• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 30 subscribers
  • Views 234 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

PCM1753: Inquiry about Audio solution

MJ Jeon
Genius 5240 points
Part Number: PCM1753
Other Parts Discussed in Thread: PCM1780, TLV320DAC3100

Hi, TI support team

I am looking for a solution including an Audio DAC to output an alarm sound to an e-cigarette.

The basic concept is to send the sound source to the DAC through I2S and output the audio by attaching a speaker to the DAC output.

It seems that the PCM1753 and PCM1780 products have analog output pins and can output 4Vp-p and 3.9Vp-p respectively.

Is it possible to compose like the simple block below?

The speaker is intended to be configured with a specification of about 0.5W.

Do I need Audio AMP between DAC and Speaker?

If there is a better, simpler way, please advise.

Also, if there are other suitable parts other than the parts mentioned above, please recommend them.

Thanks.

Regards,

MJ

  • 0
    TI__Mastermind 23280 points

    Hello MJ,

    Some DACs such as 175x family are current output DACs and thus you need to convert the output current to voltage first . In general when you use Voltage output DACs the minimum load impedance is in 1k to few kOhm  whereas speaker impedance  is 4ohm  , 8 Ohm ,  16 and etc , so  you need to put an amplifier such as The TPA31xxD2  to drive the speaker.

    Devices such as TLV320DAC3100 Low-Power Stereo Audio DAC already have speaker output built in ( as well as line output ), so I would recommend those devices.

    Regards,

    Arash