TLV320AIC3254: PurePath Studio to TLV320AIC3254

Shuji Ishiwata

Part Number: TLV320AIC3254
Other Parts Discussed in Thread: CC8520

Tool/software:

Hi All,

A customer is writing data from a cfg file created with PurePath Studio to TLV320AIC3254.
However, the following error occurred.

The cfg file output from Purepath Studio has several thousand lines and appears to have too much data.
Is there a way to avoid this error?
Are there any other tools that can be used to write?

Best Regards,
Ishiwata

3 months ago

0 Jeff McPherson 3 months ago

TI__Mastermind 32130 points

Hi Ishiwata-san,

I think there might be a little bit of confusion. The Purepath Wireless Configurator you're showing is designed to interface with a CC85XX device as the controller of your system, with the audio codec as a peripheral.

Purepath Studio is a different GUI that is for configuring the codec EVM platform to generate images used in a final system.

Since you are using Purepath Wireless, I need to know which CC85XX device you are using so I can point you to the proper team.

Best regards,
Jeff McPherson

0 Shuji Ishiwata 3 months ago in reply to Jeff McPherson

Mastermind 6430 points

Hello Jeff-san,

Thanks for the reply

The customer is using CC8520.

Best Regards,
Ishiwata

+1 Alex Fager 3 months ago in reply to Shuji Ishiwata

TI__Expert 7861 points

Hello Ishiwata,

I found the following thread, which is quite similar (or same) to the posted one, pending on Toby's investigation. Purepath Wireless is an older tool so support is limited.

https://e2e.ti.com/f/1/t/1378525/

Thanks,
Alex F

0 Shuji Ishiwata 3 months ago in reply to Alex Fager

Mastermind 6430 points

Hello Jeff-san,

Thank you for your infomation.

I will wait for Toby-san's investigation.

Best Regards,
Ishiwata

Audio

Audio forum

TLV320AIC3254: PurePath Studio to TLV320AIC3254