TAD5112-Q1: Recommended wait time between I2C command

Hello,

There is not wait time for the next I2C command.

Regards,

Arash

Hello Kazuki-san

There is no timing  requirement  b/w I2C commands beyond the  timing requirement in datasheet . The only timing requirement for this device is at power down/ power up as mentioned in section 9:

The power-supply sequence between the IOVDD and AVDD rails can be applied in any order. However, after all supplies are stable, then only initiate the I2C or SPI transactions to initialize the device. For the supply power-up requirement, t1, t2 must be at least 2 ms to allow the device to initialize the internal registers. For the supply power-down requirement, t3, t4 must be at least 10 ms.

Regards,

Arash