Tool/software:
We have generated the code according to the diagram and uploaded it successfully to our board, however we don't get any output, neither on OUT1 nor on OUT2.
We also changed some registers manually (turn on AVDD, change PLL), however we get no output signal.
It's also unclear to us for what the DSP_D_DSP_A component can be used, we tried connecting all kinds of other components to it, but it always shows error messages.
1) Is it possible to set PLL values graphically in PurePath Studio Portable?
2) What should we change in our design to get any output at all? SPI communication is working fine, we can write and read registers.
3) Can we solve this without orderding an EVK?
