TAS2563: Schematic

hi switch

team will come back and review on the Monday.

thanks

jesse

Dear Customer,

some comments:

1 I2C pull up: please check whether there is pull up at far end.

2  sdout could be used as echo reference signal if needed, of course, you can leave this pin NC if you use other signals as echo reference.

3 as you connect pin 12 to GND, it will work in I2C mode.

4 it's better to add 1k ohm resister on Vsns_N, Vsns_P trace.

5 pin17,  it's ok to leave it floating as it is NC pin. but you can also connect it to pin 16 (VBST) to enhance the soldering and the power area.

Br,

Wenbin