TLV320AIC10: Unused input on A1

Michael Rourke

Intellectual 350 points

Part Number: TLV320AIC10

Tool/software:

I am trying to determine if the A1 (-) input is floating when CR1 (Bit 6) = 0?

I am concerned about noise getting into the IC.

4 months ago

0 Jeff McPherson 4 months ago

TI__Mastermind 46515 points

Hi Michael,

If A1 is disabled, then SW2 is open while SW1 is closed, so the input to the amp will be floating, and the AURXM pin will connect to the mux. There should be no concern on noise in this case.

Best regards,
Jeff McPherson

0 Michael Rourke 4 months ago in reply to Jeff McPherson

Intellectual 350 points

Thanks, Jeff.

The words "the input to the amp will be floating" always make me uneasy.

Mike

0 Jeff McPherson 4 months ago in reply to Michael Rourke

TI__Mastermind 46515 points

Hi Michael,

You have a valid concern so let me clarify some, the input will be floating but it won't be exposed externally where it can pick up noise from the environment.

Best regards,
Jeff McPherson

0 Michael Rourke 4 months ago in reply to Jeff McPherson

Intellectual 350 points

Feeling better already!

Thank you, Jeff.

Audio

Audio forum

TLV320AIC10: Unused input on A1