TAA3040: single end SNR

Toshiro Imi

Part Number: TAA3040

Tool/software:

Hello,

Our customer has a question about single end mode SNR. Although the datasheet specify differential SNR in below, he needs to know single end SNR at AVDD=3.3V, fs=48kHz 0dB/12dB gain setting.

Could you please help our customer to know the single end SNR ?

Best regards,

2 months ago

0 Jeff McPherson 2 months ago

TI__Mastermind 46185 points

Hi Imi-san,

The SNR will degrade by about 2dB compared to Differential Mode.

Best regards,
Jeff McPherson

0 Toshiro Imi 2 months ago in reply to Jeff McPherson

TI__Expert 7190 points

Thank you for your feedback. He understood single end degraded 2dB compared with differential.

Can you fill out SNR number shown in the table below.

・TA=25℃、AVDD=3.3V/fs=48kHz (Datasheet P6)

Channel gain(0dB~42dB)	Differential Input	Single-end Input
0dB gain	104dB	102dB
6dB gain
12dB gain	100dB	98dB
18dB gain
24dB gain
30dB gain
36dB gain
42dB gain

best regards,

0 Jeff McPherson 2 months ago in reply to Toshiro Imi

TI__Mastermind 46185 points

Hi Imi-san,

I can try to collect data on this using an EVM tomorrow.

Thanks for your patience,
Jeff McPherson

0 Toshiro Imi 2 months ago in reply to Jeff McPherson

TI__Expert 7190 points

Hi Jeff-san,

Thank you very much for your help. I am looking forward to getting the data.

Best regards,

T.Imi

0 Jeff McPherson 2 months ago in reply to Toshiro Imi

TI__Mastermind 46185 points

Hi Imi-san,

I filled out the table below on an EVM. Keep in mind that this is only a single device, so it can't be treated the same as a datasheet figure, but it should be a good benchmark for the customer.

You can see that the PGA gain adds the expected 6dB degradation once the noise of the PGA dominates over the noise of the ADC.

Channel gain(0dB~42dB)	Differential Input	Single-end Input
0dB gain	104dB	102dB
6dB gain	103dB	100dB
12dB gain	100dB	98dB
18dB gain	98dB	93dB
24dB gain	93dB	87dB
30dB gain	88dB	81dB
36dB gain	82dB	76dB
42dB gain	76dB	70dB

Best regards,
Jeff McPherson

0 Toshiro Imi 2 months ago in reply to Jeff McPherson

TI__Expert 7190 points

Hi Jeff-san,

Thank you very much for your help. Our customer will check SNR performacne based on your test data, I close this Q&A and reopen if he has additional question.

Best regards,

T.Imi

Audio

Audio forum

TAA3040: single end SNR