PCM1809: PCM1809 – Support for 192kHz Sample Rate in Controller Mode

Genadi Manoilenko

Part Number: PCM1809

Tool/software:

Hello TI Support,

I would like to use the PCM1809 to sample analog audio and convert it to I2S. My application requires a 192kHz sampling rate.

Could you please confirm whether the PCM1809 supports 192kHz operation in controller mode? If so, could you advise how to properly configure the device to achieve this sample rate?

Thank you in advance for your help.

Best regards, Genadi.

22 days ago

+1 Arash Loloee 21 days ago

TI__Mastermind 29111 points

Hello Ganadi,

Page 12 of datasheet indicates: " In the controller mode of operation, the device uses the MD1 pin (as the system clock, MCLK) as the reference input clock source with a supported system clock frequency option of either 256 × fs or 512 × fs as configured using the MD0 pin. Controller mode supports fs rates of 44.1kHz and 48kHz.

Regards,

Arash

0 Genadi Manoilenko 21 days ago in reply to Arash Loloee

Prodigy 95 points

Hi Arash,

Thank you for your quick response.

Yes, I saw that. For 192 kHz, the IC is configured to 128 × fₛ, which suggests that 192 kHz operation is not supported in controller mode. I just wanted to confirm that I understood this correctly — is that right?

Best regards, Genadi

+1 Arash Loloee 20 days ago in reply to Genadi Manoilenko

TI__Mastermind 29111 points

Hi Genadi,

correct, 192 kHz operation is not supported in controller mode.

Regards,

Arash

The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.

Audio

Audio forum

PCM1809: PCM1809 – Support for 192kHz Sample Rate in Controller Mode