info on the TAS5727 in single ended mode..what about the TAS5717 ??

EMu27

Other Parts Discussed in Thread: TAS5727, TAS5717, TAS5721, TAS5707A

I see in the parametrics sheet on the TI website that the TAS5727 can be run in single ended mode, but I found nothing in the datasheet on that mode. Is this correct?

Also, is it possible to run the TAS5717 in single ended mode?? If so what would the configuration be?

Thanks

over 11 years ago

0 EMu27 over 11 years ago

Prodigy 215 points

if anyone can provide some info on this it'd be much appreciated

0 Don Dapkus over 11 years ago in reply to EMu27

TI__Guru**** 189399 points

Hi, EMu27,

Oops, it appears you have found an error in our selection guide. Both those devices are BTL-only devices.

-d2

0 EMu27 over 11 years ago in reply to Don Dapkus

Prodigy 215 points

Thanks for the information Don

I'm looking for a single ended device in the TAS57XX family that will do 10watts per channel at 8ohms it look like the lowest cost device would be the TAS5721, am I correct?

Thanks

0 Don Dapkus over 11 years ago in reply to EMu27

TI__Guru**** 189399 points

Hi, EMu27,

What about TAS5707A? Did you look at that one?

-d2

0 EMu27 over 11 years ago in reply to Don Dapkus

Prodigy 215 points

I did look at the TAS5707A but it's BTL according to the data sheet and parametric search.

Audio

Audio forum

info on the TAS5727 in single ended mode..what about the TAS5717 ??