Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

  • State
  • Locked Locked
  • Replies 2 replies
  • Subscribers 28 subscribers
  • Views 370 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TPA6100A2 Usage of the BTL Mode

Sadanori Kato
Guru 36530 points
Other Parts Discussed in Thread: TPA6100A2

Hi,

We have obtained a request from our customers regarding the audio power amp.
Is there audio power amp where the power supply voltage operate in 1.5V?
Although we found TPA6100A2 where the power supply voltage operate in 1.6V as the headphone amp, is it possible to use with the BTL mode?
Could you please advise us about it?

Best Regards,
Kato

  • 0
    TI__Mastermind 37045 points
    Hi Kato-san, What is the load and Po requirement? Output DC blocking caps acceptable? If the input signals are out of phase, BTL mode maybe possible but need to consider the OC limit and output offset voltage. reg, Paul.
  • 0 in reply to user5276421
    Guru 36530 points

    Hi Paul-san,

    Thank you for your reply me even though you are busy.
    We believe that our customers need the speaker load of 8Ω or 16Ω, use dc-coupling.
    But we have not obtained information of output power from our customers.
    When we use TPA6100A2 with BTL mode(the load of 8Ω and 16Ω, power supply voltage of 1.6V and 3.6V),
    could you please tell us the maximum continuous output power?
    In addition, we could not find the description in the data sheet regarding the current threshold of the short circuit protection.
    Could you please tell us about it?

    Best Regards,
    Kato