Sample code for configuring TAS2505 in speaker mode

Prashanth Kumar N

Other Parts Discussed in Thread: TAS2505

Hi,

Currently i have a design using CC256x BT module and TAS2505, wanted to check if TI has a sample code for i2C configuration in speaker mode? I did by reading the Application note but feel something is not write... Any help you be of great help.

Thanks

Prashanth

over 11 years ago

0 Don Dapkus over 11 years ago

TI__Guru**** 189401 points

Hi, Prashanth,

Are you copying the TI Design? The one I am referring to is here.

There is an Application Reference Guide for the TAS2505, you can find it here. There are sample scripts starting on page 40.

0 Prashanth Kumar N over 11 years ago in reply to Don Dapkus

Intellectual 470 points

Thanks Don for the reply. My dsign is replica of TI design. I did check this y'day and hope you are referring to the below one

4.0.7 Example Register Setup to Play Digital Data Through DAC and Headphone/Speaker
Outputs

Here i see reference to running the script, i am not aware on how to run the script?

Is this in some kind of terminal?

As i am using TI I2C C library, was thinking there would be a example build around this... hope i was not asking for too much here :)

Any pointers here would be helpful.

-Prashanth

0 Prashanth Kumar N over 11 years ago in reply to Prashanth Kumar N

Intellectual 470 points

Any chance to look at this?

-Prashanth

0 Miguel over 11 years ago in reply to Prashanth Kumar N

TI__Mastermind 23565 points

Prashanth,

There is an example script for the TAS2505 in speaker mode in our MSP430 SDK. It can be reused for the TivaC since it is an array of bytes.

http://www.ti.com/tool/stonestreetone-bt-sdk

Regards,

Miguel

Audio

Audio forum

Sample code for configuring TAS2505 in speaker mode