DIT4192 transfer distance?

Hi, Nat,

Welcome to e2e, and thanks for your interest in our products!

On the EVM for the DIX4192 (a higher performance device similiar to the DIT4192), we used a SN74AHCT1G125DBV to buffer the signal. You can see the schematic we implemented on the EVM. (click here).

-d2

It is not easy to answer. It depend on many parameters.

1. For balanced output you will get range probably over 10 meters for 192kHz. With lower sampling speed it will work on longer wire. It also depend on wire quality and his impedance which must be ideally 110Ω.
Recommeded output circuit is in datasheet. For transformer you can use pulse transformer DA102C or PE-65612 or S22083 or LL1572. You don't need external driver because it is included in the DIT4192.

2. For unbalanced output you will get range about few meters. Voltage 5V is too high that there is used 2:1 transformer and other resistor for match impedance. In my construction I use simple voltage divider if I don't need isolated output.
Like here: http://www.pavouk.org/hw/purepathwireless/en_index.html
And also you don't need special driver because it is also included in the chip.
You will use only one TX pin. Usually TX+ and TX- will be unconnected.
Cable must be high-quality coaxial cable with impedance 75Ω. Ideally thick cable for video.

Best regards, Pavel.