TAS5710

toshi-e2e

Other Parts Discussed in Thread: TAS5710

Hi all,
About TAS5710, could you please share the following value?

1.The value of an over current detection current
2. The detection timing when OC occurred?
3. The value of pull-up / pull-down termination register on LRCLK, RESET, and etc..

Thanks in advance.
Regards,
Toshi

over 10 years ago

0 Diego Melendez over 10 years ago

TI__Guru 57800 points

Hi, Toshi-san,

The overcurrent protection of the TAS5710 is used to detect any shorts across the load, to GND, or to PVCC so we don't specify a typical value. The typical shutdown response time is around 1.5µs.

Best Regards,

-Diego Meléndez López
Audio Applications Engineer

0 toshi-e2e over 10 years ago in reply to Diego Melendez

Genius 4860 points

Hi Diego-san,
Thanks for your answer.
Could you tell me the value of Pull-up/Pull-down registers?

Thanks and regards,
Toshi

Audio

Audio forum

TAS5710