Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

  • State
  • Locked Locked
  • Replies 3 replies
  • Subscribers 30 subscribers
  • Views 901 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LM4995 / 8Ohm replace 4Ohm SPK Solution

Gerald Choi
Expert 1400 points
Other Parts Discussed in Thread: LM4995

Dear TI employee

I know that LM4995 Audio Amp output spec is 8Ohm 1.3W

We want to use 4Ohm, 3W spk and should be using LM4995 now.

Do you have any solution and reference schematic?

I wait your fast reply.

If you have a question. any time contact me.

Thanks a lot

  • 0
    TI__Mastermind 20085 points
    Hi Gerald

    You should take into account the power dissipation because it is higher with 4Ω. You can refer the AUDIO POWER AMPLIFIER DESIGN section of the amplifier's datasheet to find reference schematic.
    Please Let me know if you have more questions.

    Best Regards
    Jose Luis Figueroa
    Audio Applications Engineer | A-Team
  • 0 in reply to José Luis
    Expert 1400 points

    Hi Jose
    Thank you for your reply

    I knew that Po(Output Power) typical is 1.3W. 
    However, It isn't show Output power Limit on datasheet.

    can we know Limit Output power(W)?

    If you have a question. any time contact me.
    Thanks a lot.

  • 0 in reply to Gerald Choi
    TI__Mastermind 20085 points
    Hello Gerald

    You can refer to the figure 23 of the amplifier's datasheet to find that output power is almost 2W at THD+N=10%. The output power would be higher with a load of 4Ω, but you should take into account the power dissipation in the device.

    Best Regards
    Jose Luis Figueroa
    Audio Applications Engineer | A-Team