TAS5624 / ROC-ADJUST setting

Philip Kiehnle

Other Parts Discussed in Thread: TAS5624, TAS5624AHi,

i have the exact same question. In the datasheet it only says "Depending on the application, this resistor can be
between 24 kΩ to 68 kΩ".

Best regards,
Philip

over 8 years ago

0 Adam Sidelsky over 8 years ago

TI__Guru 65420 points

Philip,

I moved your post as that old thread is closed.

You're asking about what ROC value you should select?

Please let us know: Mode of operation (BTL, PBTL, SE), output load, PVDD voltage, output power target, output LC filter component values and model numbers.

Regards,

-Adam

0 Adam Sidelsky over 8 years ago in reply to Adam Sidelsky

TI__Guru 65420 points

Also, please confirm you are using TAS5624.

0 Philip Kiehnle over 8 years ago in reply to Adam Sidelsky

Prodigy 30 points

yes i am asking what ROC value i should select and how it correlates with the possible output current. I will be using TAS5624A in BTL configuration. The speaker impedance will be 4 Ohm.
PVDD = 24V
L = 10µH
C = 1µF
Pout = 100W

Audio

Audio forum

TAS5624 / ROC-ADJUST setting