PurePathConsole 3 shows only generic I2C

Janis Irbe

Other Parts Discussed in Thread: TAS5782MEVM, TAS5756M, TAS5754M

Hi,

I've purchased TAS5782MEVM Eval board, and successfully requested, downloaded and installed PPC3. Board is recognized. However after successful App center sign-in "Available EVM Apps" section in PPC3 doesn't show any amp specific I2C GUI controls, only generic I2C, see attached picture:

This is contrary to slou408 [PPC3 User Manual].pdf where particular TASXXXX device GUIs are shown as examples:

Any suggestions about the possible cause and resolution?

Sincerely,

Jānis Irbe

over 7 years ago

0 Jeff Kohnle over 7 years ago

TI__Expert 6985 points

Hello Janis! You also need the TAS5782 GUI plug-in, which I can send to you if you can provide me with the email that you have attached to your ti.com account. Thanks, Jeff

0 Jeff Kohnle over 7 years ago in reply to Jeff Kohnle

TI__Expert 6985 points

Hello Janis! You should soon receive an approval message with a link to the plug-in. I also gave you access to the TAS5780 and TAS5766 in case you ever need them. This should solve your problem and please do let us know if you have any further questions. Thanks, Jeff

0 Janis Irbe over 7 years ago in reply to Jeff Kohnle

Prodigy 55 points

Thanks Jeff, I received approval!

Does PPC3 has also plugins for TAS5754M/TAS5756M? I have also EVM boards of one of those, and it would be great not having to switch from PPC2 to PPC3 every time I swap amp boards on motherboard.

Sincerely,

Jānis

0 Jeff Kohnle over 7 years ago in reply to Janis Irbe

TI__Expert 6985 points

Hello Janis! Unfortunately, somewhat older products like the TAS5754M/TAS5756M are only supported by the PurePath Console 2 tool. All newer, and future products will be on PPC3. Thanks, Jeff

Audio

Audio forum

PurePathConsole 3 shows only generic I2C