TAS5711PHPEVM: how to set (L+R)/2 for the Mode2.0

Hsu Marks

Prodigy 150 points

Part Number: TAS5711PHPEVM

Hi Team,

How to set the R and L channel output single to (R + L) /2 at Mode 2.0

over 6 years ago

0 Shawn Zheng over 6 years ago

TI__Mastermind 24835 points

Hi Marks,

You can use the input mixer to generate (R+L)/2 on channel 1 and channel 2. Please refer to the following figure.

Best regards,

Shawn Zheng

0 Hsu Marks over 6 years ago in reply to Shawn Zheng

Prodigy 150 points

Hi Shawn,

Could you provide your PPS GUI version and download link.

This version is download form TI web site, i can't see about 0x55 component.

0 Shawn Zheng over 6 years ago in reply to Hsu Marks

TI__Mastermind 24835 points

Hi Marks,
The GUI which you are using is the latest revision, and the MUX 0x55 is not shown in it. Please write the register directly to configure the MUX. The whole architecture of the device is shown in the picture on Page5 in the datasheet. You could program the device according to this picture.
Best regards,
Shawn Zheng

0 Shawn Zheng over 6 years ago in reply to Shawn Zheng

TI__Mastermind 24835 points

Hi Marks,

Let us know if it's not clear for you. Could you please help to close this question if there is no more other one?

Best regards,

Shawn Zheng

0 Hsu Marks over 6 years ago in reply to Shawn Zheng

Prodigy 150 points

thanks

Audio

Audio forum

TAS5711PHPEVM: how to set (L+R)/2 for the Mode2.0