• State
  • Locked Locked
  • Replies 3 replies
  • Subscribers 30 subscribers
  • Views 905 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DIT4096: Asking for the DIT4096 schematic review

SHH
Mastermind 32206 points
Part Number: DIT4096

Hi Team,

customer would like to use DIT4096.
could you please help review the DIT4096 schematic?

password: "ti"

https://e2e.ti.com/cfs-file/__key/communityserver-discussions-components-files/6/5265.DIT4096.7z

here is the light transmitter. please provide your comment if this is not ok.

6518.2B.13157.021.pdf

Thanks,
SHH

  • 0
    TI__Expert 5645 points
    Hi SHH,
    I'll take a look at the SCH and will have my comments by Monday (30Oct2017). Thanks for the support.

    Best regards,
    Ravi
  • 0 in reply to Ravi Patil
    TI__Expert 5645 points
    Hi SHH,
    As I was reviewing the SCH, I was not sure if you want to pull CSS pin (PIN 1) on the device high or low...can you please confirm of the one of the pull-up/down resistor is NC/no pop on the SCH as it's not clear from the comment? All other things look good and based on the DS for the TX, it should be work in this application.

    Please clarify wrt CSS pin and based on the feedback, we can finalize the review. Thanks.

    Best regards,
    Ravi
  • 0 in reply to Ravi Patil
    TI__Mastermind 32206 points

    Hi Ravi,

    customer would like to set the HW mode at pin1.

    Could you please advise how to set the following pins GPIO?

    CSS= high?

    COPY

    U

    V

    L

    Thanks,

    SHH