TAS5751M: PPC3 In-System Tuning

Mason Noh

Expert 2490 points

Part Number: TAS5751M
Other Parts Discussed in Thread: PUREPATHCONSOLE,

I'm using PurePathConsole to test TAS5751M.

I want to configure my board with PurePath Console Motherboard(rev.G). So I use the In-System tuning.

But my board is not controled by PPC3.

I connected SDA,SCL and GND to motherboard.

It need another setting?

over 6 years ago

0 Shawn Zheng over 6 years ago

TI__Mastermind 24835 points

Hi Mason,
On the upper right corner of the PPC mother board, you could find the red connecter with '4V' maker. Please supply 4V power to it. Or you could also connect the '+5V USB' power on the upper edge of the board to '4V'. I believe you could make it working.
Best regards,
Shawn Zheng

0 Mason Noh over 6 years ago in reply to Shawn Zheng

Expert 2490 points

Thank you~ Shawn
It is working very well.
I have another question.
I would like to read register saved on my board using PPC3. Is it possible?

0 Shawn Zheng over 6 years ago in reply to Mason Noh

TI__Mastermind 24835 points

Hi Mason,

Please refer to the section 'Dump Current State into a Header File' on page 13 in the TAS5751M EVM user's guide

Best regards,

Shawn Zheng

Audio

Audio forum

TAS5751M: PPC3 In-System Tuning