• State TI Thinks Resolved
  • Locked Locked
  • Replies 4 replies
  • Answers 2 answers
  • Subscribers 31 subscribers
  • Views 563 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Electromechanical audio transducer driver

subramani pasupathy
Intellectual 575 points
Other Parts Discussed in Thread: LM48560, TAS2562, TPA2100P1

Can we connect Electromechanical audio transducer to audio amplifier.

The specification of the transducer is 

RATED VOLTAGE                              12 Vpk
OPERATING VOLTAGE RANGE        8 ~ 14 Vpk
RATED CURRENT (MAX)                  55 mA
COIL RESISTANCE                           120 OHM
MINIMUM SPL @ 10 CM (@ 1kHz)   85 dBA
RESONANT FREQUENCY                1,000 - 1,500 Hz

We have connected 3.3V/5V to supply voltage of the IC

I am looking for an audio amplifier that can drive this audio transducer.

Thanks

regards

Subramani

  • 0
    TI__Guru* 84915 points
    Hi,

    Our team will take a look at this issue. We will reply as soon as possible.

    Best regards,
    Luis Fernando Rodríguez S.
  • 0 in reply to Luis Fernando Rodriguez S.
    TI__Guru* 84915 points
    Hi,

    We have few suggestions for your requirements:

    TPA2100
    LM48560
    TAS2562

    However, we have had much testing on this. If you could share the transducer datasheet and more details, we could provide a better solution and do some tests.

    Please let me know if you have additional questions or comments.

    Best regards,
    Luis Fernando Rodríguez S.
  • 0 in reply to Luis Fernando Rodriguez S.
    Intellectual 610 points
    Hi Luis,
    The following are the Electromagnetic speaker part numbers which we need to drive


    1. AS02708CO-WR-R
    2. AS04008CO-WR-R
    3. WSP-5008-57

    Also we need to drive the following Piezo speakers with capacitance of maximum of 1uF

    1. APS2513S-T-R
    2. APS3008S-R

    Is there any amplifier which can drive both Piezo and Magnetic speakers which are listed above


    We can provide 3.3V/5V to supply voltage of the amplifier. And audio analog input is provided by DAC from controller.


    Thanks and regards,
    R.Sivasuryan
  • 0 in reply to sivasuryan.R
    TI__Guru* 84915 points
    Hi, Subramani,

    Regarding your question about all the speakers parts, the first three inductive speakers ( AS02708CO-WR-R, AS04008CO-WR-R, WSP-5008-57) could be driven with some devices that I suggested in previous responses (LM48560, TAS2562). They all support this kind of loads.

    Regarding the piezo speakers, you may take a look at the TPA2100P1 or the devices in our piezo speaker driver portfolio ( www.ti.com/.../products.html ).

    Unfortunately, due to the differences between all the speakers, you would require different drivers to use them. If you use a different device than those that I suggested, there could be a wrong behavior or even the risk to damage the speaker.

    Best regards,
    Luis Fernando Rodríguez S.