• State TI Thinks Resolved
  • Locked Locked
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 31 subscribers
  • Views 1070 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

OPA1632: Single power supplies

Went Cao
Genius 5550 points
Part Number: OPA1632

Dear all

       The OPA1632 device can support single power supplies, and in the datasheet of OPA1632, it said THD + Noise characteristics at section 6.6 Typical Characteristics, but it based on the VS = ±15 V dual power supplies, Could you tell me the THD + Noise at single power supplies is same to dual power supplies ? Is there test data ?

  • 0
    TI__Expert 8000 points

    Hi, 

    The THD+ Noise data should be the same for single and split power supplies. However, in practical applications there is often more noise on a ground plane in a board than on a dedicated negative power supply and that can cause some loss in performance. Therefore it is important to always make sure you are not coupling any additional noise into the part from the ground. 

    Regards, 

  • 0 in reply to Jacob Freet
    Genius 5550 points

    Dear Jacob

            Thank you!

            But I have other question,as below picture from OPA1632 datasheet, I want to know there is need capacitance before R1 and R2 ?

  • 0 in reply to Went Cao
    TI__Expert 8000 points

    Hi, 

    You do not need capacitors before R1 and R2, but you will need to make sure the amplifier is biased properly if you are connecting a DC coupled input signal. What is the common-mode of your input signal?

    Regards,