OPA1664: Help in component selection

dinesh gupta

Intellectual 310 points

Part Number: OPA1664

I am using opamp as a voltage follower for one application. I am using a filter circuit for the output as shown below.

Can anyone suggest how to select the values for diode, transistor and resistor values?

Thanks in advance.

Dinesh

over 5 years ago

0 Iwata Etsuji over 5 years ago

TI__Expert 6400 points

Hi Daniel,

Could you please clarify the expected filter response, i.e. cut-off frequency, stop band, etc.?
While, I suppose your schematic looks output clamp circuit.
If you expect also the specific clamp level, could you please tell us the clamp voltage or current value?

Best regards,
Iwata Etsuji

0 Tamara M Alani over 5 years ago

TI__Genius 10850 points

Hi Dinesh,

We haven't heard from you in a while, we hope the issue was resolved. Please reply to re-open if you have any additional questions.

Audio

Audio forum

OPA1664: Help in component selection