This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi
I am using opamp as a voltage follower for one application. I am using a filter circuit for the output as shown below.
Can anyone suggest how to select the values for diode, transistor and resistor values?
Thanks in advance.
Dinesh
Hi Daniel,
Could you please clarify the expected filter response, i.e. cut-off frequency, stop band, etc.?
While, I suppose your schematic looks output clamp circuit.
If you expect also the specific clamp level, could you please tell us the clamp voltage or current value?
Best regards,
Iwata Etsuji
Hi Dinesh,
We haven't heard from you in a while, we hope the issue was resolved. Please reply to re-open if you have any additional questions.