TSW14J57EVM: download FPGA sof file failed, when using usblaster

Li Yang

Part Number: TSW14J57EVM
Other Parts Discussed in Thread: AFE7422

do as the user guide,when download sof file as page 6, occur error. I had tried many times.do I need to change some jumpers.

A10 AFE74xx XCVR 2x44210 JESD Reference Design User Guide.pdf

over 3 years ago

0 jim s over 3 years ago

TI__Guru* 91947 points

Li,

The part you need to target on this EVM is a 10AX115H1F34E1SG. You are showing a different part in your Quartus screen shot. No jumper changes are required. Make sure the 12V input can provide at least 3A of current.

Regards,

Jim

0 Li Yang over 3 years ago in reply to jim s

Prodigy 100 points

Thank you very much， where i can get a reference design for TSW14J57 rev E.

0 jim s over 3 years ago in reply to Li Yang

TI__Guru* 91947 points

Li,

You can download an example ADC reference design from the following link:

https://tidrive.ext.ti.com/u/igbDhZEGw5CYBsOC/370a12e0-1fad-4935-aec7-67a7ecf2262b?l

Regards,

Jim

0 Li Yang over 3 years ago in reply to jim s

Prodigy 100 points

Jim

exactly，I want a TSW14J57 rev E work with AFE7422,if you have，thanks again.

Regards,

0 jim s over 3 years ago in reply to Li Yang

TI__Guru* 91947 points

Li,

This is the source code used for the AFE7422 interface. Not sure if what I sent you earlier was the correct firmware.

Regards,

Jim

TSW14J57RevE_AFE7422.zip

0 Li Yang over 3 years ago in reply to jim s

Prodigy 100 points

Quartus let me upgrade the IP ,but failed.

0 jim s over 3 years ago in reply to Li Yang

TI__Guru* 91947 points

I suggest you contact Intel. This firmware was developed by a third party for TI and is no longer supported by them. Any reason you cannot compile this firmware with Quartus version 14.0?