• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 47 subscribers
  • Views 289 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

ADS130E08: Can not get the chip ID

wenwu wang
Prodigy 70 points

Part Number: ADS130E08
Other Parts Discussed in Thread: ADS131E08

Hi, everyone

We used the ADS130E08 to make a sample .

But can not read back the  chip ID by SPI bus, the START/Reset/PWR_DN/ DIN/DOUT/CLK/ looks fine

if there are any  suggestion for me to check again?

 ADS131E08_V0.1.pdf

  • 0
    TI__Guru 69076 points

    Hello Wenwu,

    Thank you for your post.

    Are you able to capture the SPI RREG command frame on a logic analyzer or scope? If so, please share the waveforms so that we can check the commuication.

    Are you following the power-on reset timing correctly? After supplies have ramped, you should issue a pulse to the RESETn pin as described in the Power-Up Sequencing section.

    Regards,

    Ryan