TSW14J58EVM: How to set the capture flag and the capture done bit when use the HSDC software?

Ge Jiawei

Part Number: TSW14J58EVM
Other Parts Discussed in Thread: TRF1208, AFE7950

As shown in the figure above, when I was doing a single-tone FFT test, there's an error.I don't know how to set the capture flag and the capture done bit. My capture options is shown below.

Fig.2

over 1 year ago

0 Chase W over 1 year ago

TI__Mastermind 23880 points

Hi Ge,

This typically happens when the reference clock is not correct for the FPGA.

Can you confirm the ADC EVM you are using as well as the JESD mode? This will allow our expert to provide assistance on this.

Thanks, Chase

0 Ge Jiawei over 1 year ago in reply to Chase W

Prodigy 20 points

Hi chase,

What I use is TRF1208 AFE7950 EVM and DC182 REV-A9 TSW14J58 EVM.

Thank you for your reply.

0 Hruday Kumar Mudireddy over 1 year ago in reply to Ge Jiawei

TI__Expert 4550 points

Hi Ge,

Is this issue resolved or are you still looking for support?

Thanks,

Hruday

Data converters

Data converters forum

TSW14J58EVM: How to set the capture flag and the capture done bit when use the HSDC software?