• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 46 subscribers
  • Views 368 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

ADC12DJ5200RF: Output Sample Rate and Bandwidths in Single-Channel Mode (DES Mode)

Kazuhiko Hirano
Genius 15348 points
Part Number: ADC12DJ5200RF


Tool/software:

Hello,

The datasheet table 6-12 shows “Output Sample Rate and Bandwidths”.
Is this under dual-channel mode?
In case of single-channel mode (DES Mode), the output rate and max alias protected signal bandwidth get twice?

Best regards,

K.Hirano

  • 0
    TI__Expert 6150 points

    Hello Hirano-San,

    In the case of dual channel f_dev_clk will be whatever sampling frequency is input to the device e.g. 5GHz. In single channel this will be double. So depending on which mode of operation you are using the part in you will have to calculare the f devclk correctly then use the other equations.

    Thanks,

    Eric