Hello,
I am using three DDC316 at one SPI.
After Power on, I can read the first Four Channles of the first DDC316.
If I try to switch the DDC316 in DaisyChain Mode by writing the Configuration Bits, DValid is still high after the last Bit.
Here is a Scope Plot:
Yellow=CLK, Blue=DIN_CFG, Green=DVALID, Red=DCLK
For a better view here again:
The CONV Signal is still by one Level.
But The DVALID Signal leves still high and nothing changed.
Has anyone a Idea what is going wrong?
Greetings Robert
Hello Admins,
excused me but I thinking I am absolutly wrong here with my question.
Would it be able to move this posting to the 'Precision Data Converters Forum', I guess it is better placed there.
Thank You, Robert