Tool/software:
Dear TI Support Team,
I am currently using the ADC12DJ5200RF and would like to ask about foreground calibration in relation to JMODE switching.
After performing a foreground calibration for a certain JMODE, I plan to change the JMODE to a different setting after sometime. Since the decimation setting may also change when switching JMODEs, I would like to confirm whether it is necessary to run foreground calibration again after the change, or if the previous calibration results remain valid.
Additionally, if there is information available about the typical time required for foreground calibration, could you please share it with me?
Thank you very much for your support.
Best regards,
Jeongju Go