ADS1291

david sun77114

Expert 2162 points

Other Parts Discussed in Thread: ADS1291

how to get a ADS1291 demo board schematic in Orcad format? thanks

over 13 years ago

0 Tony Calabria over 13 years ago

TI__Mastermind 43915 points

Hi David,

The demo board was not done in Orcad but instead done in PADs. I have attached the PADs schematic to this email if you want to attempt to do some sort of conversion.

Regards,

Tony Calabria

ECG Recorder_Board_Schematic_ADS1292R_V14_Aug22_PADS_with DNI_A.sch

0 david sun77114 over 13 years ago in reply to Tony Calabria

Expert 2162 points

thank you very much, I don't know how to convert it. is any one know how to convert it to Orcad? I will post this question to Cadence support forum.

0 david sun77114 over 13 years ago in reply to david sun77114

Expert 2162 points

the only way to convert to Orcad is by Elgris tools or their service. can anyone shares an Orcad format of ADS1291 design?

thanks,

David

0 david sun77114 over 13 years ago in reply to Tony Calabria

Expert 2162 points

Hi Tony,

if you have PADs design tools, could you please help me export it to a .txt file? please choose select all in ASCII output pop up, and output to 2004.X format.

Best Regards,

David

0 david sun77114 over 13 years ago in reply to Tony Calabria

Expert 2162 points

Hi Tony,

This is David again, if you could and would to export the PADs to txt format, please only export page 2. Because the method I learned only do one page at a time. I only care the ADS129x page.

Best Regards,

David

0 Tony Calabria over 13 years ago in reply to david sun77114

TI__Mastermind 43915 points

Hi David,

That option was not available. Attached is what we could provide extracting the file you asked.

Regards,

Tony Calabria

0 japex92 over 13 years ago in reply to Tony Calabria

Prodigy 70 points

Hello Tony, I download the file you posted but I seems it does not run on Eagle cadsoft 6.2, have you got suggestions to solve this out?

Thanks

0 Tony Calabria over 13 years ago in reply to japex92

TI__Mastermind 43915 points

Hi Jairo,

I do not have Eagle cadsoft so I cannot comment on how you can import it. I have given you all the files which we have here. You may have to rebuild the board and use our provided schematic and gerber files to help.

Regards,

Tony Calabria

Data converters

Data converters forum

ADS1291