ADS1248 installation issues

OscarM.

Other Parts Discussed in Thread: ADCPRO, ADS1248EVM-PDK

Dear Support Team,

I have an issue with a ASD1248PDK installaiton. After following the installation guide, I stuck on the picture nr 12 (page 14).

When setting the SW4 as said in the user guide and pressing OK, the green "Improper BSL version" sentence appears in ADCPro and it goes back to the frame from picture nr 12. On the other PC it doesn't work as well - is there a problem with bootloader? What to do?

thanks, best regards

Oskar

over 16 years ago

0 Richard Oed over 16 years ago

TI__Intellectual 875 points

Oskar,

You can try the following:

Shut down ADCPro
Remove the USB-cable
Wait for a couple of seconds
Re-connect the USB cable
Re-start ADCPro

This should solve the problem.

Regards,
Richard

0 BOUQUET Hugo over 15 years ago in reply to Richard Oed

Prodigy 130 points

Hello,

I have the same problem ... I try richard's solution but it doesn't work. Some times I've the improper BSL version message and sometime the programing failed message.

Is anybody has a solution ?

It's the first time I power up the ADS1248EVM-PDK, the driver is ok but what i find strange is the "BRD TEST" message on the LCD wich disappears each time I change the SW4 position to the BSL position.

The other thing is the green led at the left side of the LCD which is only lights on for 1s when I plug the USB cable and shut down after.

Is it normally ?

I'va create a new post for this problem : http://e2e.ti.com/support/data_converters/precision_data_converters/f/73/p/37155/129725.aspx#129725

Data converters

Data converters forum

ADS1248 installation issues