• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 46 subscribers
  • Views 215 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

USING PGA on ADS1259 EVM

Abhay Kothari1
Prodigy 240 points
Other Parts Discussed in Thread: ADS1259, PGA280

Hi,

We are developing a system with PGA 280 and ADS1259 for which we have purchased the ADS1259-EVM, with the MMB0 motherboard,

I am presently trying to test PGA 280 with a launchpad using SPI ,Should i change any jumpers on the EVM??

Will the motherboard cause any interference (it is plugged in)???

Regards

Abhay

  • 0
    TI__Mastermind 44680 points

    Hi Abhay,

    You'll need to look at the ADS1259EVM User's Guide to determine the necessary jumper settings. I don't think you have to make any changes, but you will need to decide if you are controlling the ADS1259 directly, or through the PGA280 using its extended chip select mode.

    Regarding the MMB0 interfering with SPI communication, I think it is safest to assume that it will interfere. You could de-solder J7B from the ADS1259 (removing the digital connections between the MMB0 and ADS1259EVM), and only use the MMB0 to power the ADS1259EVM; however, you would still need to short the LaunchPad and the MMB0 grounds to make sure the ground reference voltages are the same.

    Best Regards,
    Chris