MatLab Simulink and TSW1400

Gor Hovsepyan

Other Parts Discussed in Thread: AFE7222

Hi all. I have a Simulink model of Tx/Rx IP Core. I would like to know can I connect my Simulink model output to TSW1400, which is connected to AFE7222. If not, is there any way to connect AFE7222 to PC(Simulink model).

Thanks in Advance!!

over 11 years ago

0 Ken C over 11 years ago

TI__Genius 12965 points

Gor,

HSDC Pro does allow control from Matlab - you may be able to use this to capture data and send data to HSDC Pro and consequently any device connected to HSDC Pro.

Look in this directory for an MATLAB example code:

C:\Program Files (x86)\Texas Instruments\High Speed Data Converter Pro\HSDCPro Automation DLL

Ken.

0 Gor Hovsepyan over 11 years ago in reply to Ken C

Intellectual 390 points

Dear Ken,

Thank you for quick response.

As far as I understood I should save Simulink data in *.csv file and than capture it by HSDC Pro? Is there any option of direct passing (Simulink to HSDC Pro) without modifying output data of Simulink model?

Thanks,

Gor Hovsepyan

0 Ken C over 11 years ago in reply to Gor Hovsepyan

TI__Genius 12965 points

Gor,

Unfortunately no. HSDC Pro was never intended specifically for this purpose and as such is not optimized in this manner.

Ken.

0 Gor Hovsepyan over 11 years ago in reply to Ken C

Intellectual 390 points

Ken,

Thank's very much!

Best Regards,

Gor

Data converters

Data converters forum

MatLab Simulink and TSW1400