AFE4490 GUI reference code and EVM USB protocol for customer use

Patrick Chen

Other Parts Discussed in Thread: AFE4490, AFE4490SPO2EVM

Hello,

Couldwe provide PC GUI reference code and USB protocol to PC of our EVM to customer? Customer would like to build their own application on PC to use our AFE4490 EVM. Thank you.

Patrick

over 10 years ago

0 Amy Schnoor over 10 years ago

TI__Mastermind 18285 points

Patrick,

Unfortunately we don't provide our labview source code.

0 Patrick Chen over 10 years ago in reply to Amy Schnoor

Mastermind 8875 points

Hello,

Thanks. Is it possible to provide USB protocol of AFE4490 EVM to PC to customer? Do we have any reference doc. to provide for customer? Thank you.

BR
Patirck

0 Amy Schnoor over 10 years ago in reply to Patrick Chen

TI__Mastermind 18285 points

Patrick,

Our firmware source code is available. You may give the customer this to look at. I included the link to our product folder below.

www.ti.com/.../toolssoftware

0 yihua chen over 10 years ago in reply to Amy Schnoor

Prodigy 10 points

Hi,
I have the same question:
Is it possible to program GUI for afe4490spo2evm
by using CCS and GUI composer?

0 Amy Schnoor over 10 years ago in reply to yihua chen

TI__Mastermind 18285 points

Yihua,

Unfortunately, our GUI was done using Labview and we don't release that source code. However, our firmware was done using CCS and IAR and that source code we do release. I have included that link in my previous post above.

Data converters

Data converters forum

AFE4490 GUI reference code and EVM USB protocol for customer use