DAC5652

itabi

Expert 1295 points

Other Parts Discussed in Thread: DAC5652

Hi,

Regarding Iout of DAC5652,
Clock latency(tLAT) is 4clK.(datasheet page 7)

My customer have a problem that Iout is sometimes outputted after 5clk.
Please refer to attachment data.

What is considered as a problem?

Best Regards,
itabi

DAC5652_waveform.pdf

over 11 years ago

0 Joseph Wu over 11 years ago

TI__Guru** 100925 points

Itabi-san,

I've moved this post into the High Speed Data Converter Forum. You should be able to find an answer to your question here.

Joseph Wu

0 Neeraj Gill over 11 years ago in reply to Joseph Wu

TI__Mastermind 20541 points

HI Itabi-san,

what does the purple signal(DA4) on the scope shot represents?

Regards,
Neeraj Gill

0 itabi over 11 years ago in reply to Neeraj Gill

Expert 1295 points

Hi Neeraj Gill-san,

The purple signal(DA4) is Digital input (4pin).
DA0 ->DA9 are same timing.

-Bus input : Dual-bus mode
-setup time ,hold time : 1nsec

Regards,
itabi

0 Neeraj Gill over 11 years ago in reply to itabi

TI__Mastermind 20541 points

Hi Itabi-san,

Looking at the figure that you sent me it looks like they are getting the Iout after 4 clk cycles which is as expected. Even if they are getting it after 5 clk I don't think this would be a problem.

Regards,
Neeraj Gill

0 itabi over 11 years ago in reply to Neeraj Gill

Expert 1295 points

Hi Neeraj Gill-san,

Thank you for your answer.

There are 2 figures in attached file.
Page1 is 4 clk ,and page2 is 5 clk.

My customer said Iout is sometimes outputted after 5 clk.

Regards,

itabi

Data converters

Data converters forum

DAC5652