• State Resolved
  • Locked Locked
  • Replies 3 replies
  • Subscribers 46 subscribers
  • Views 5694 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Electromyography EMG circuit

Marc_o
Prodigy 55 points

Other Parts Discussed in Thread: ADS1291, ADS1292ECG-FE, INA128

Hi,

does anyone have experience with simple EMG device design using ADS1291 (Low-Power, 2-Channel, 16-Bit Analog Front-End for Biopotential Measurements )?

Do you have any suggestions about that circuit? Any design?

Thank you

  • 0
    TI__Guru**** 182761 points
    Hi Marc_o,

    Have you reviewed the ADS1292ECG-FE documantation yet? That would be a good place to start.
  • 0 in reply to Tom Hendrick
    Prodigy 55 points

    Hi,

    thank you for your answer. 

    yes, I checked it thank you. 

    If I understand correctly those connections below... can you please check it? I am not sure because of the amplifier - gain 12 is probably not enough for EMG (as it needs at least 100 or 1000... )

    On the other hand I was wondering if it would be enough only to choose INA128 and one data acquisition card...

    Is it OK if I connect reference electrode to the ground?

    What do you suggest?

    Thank you

  • 0 in reply to Marc_o
    TI__Guru**** 182761 points
    Hi Marc_o,

    Yes, that would be fine. I'd suggest that you use a fixed resistor to set the gain on the INA though. Starting with a pot to prototypr is fine, but once you've decided on a value, change the pot to a fixed resistor.