ads1192 development kit

Rushin Thakkar

Other Parts Discussed in Thread: ADS1192ECG-FE, ADS1292ECG-FE, ADS1292

hello there here

can we use this kit as oscilloscope. like if i will give it input as sine wave from function generator and will it display on pc??

over 10 years ago

0 Ryan Brown1 over 10 years ago

TI__Guru**** 223357 points

The link you posted is broken but you are referring to the ADS1192ECG-FE. Moving this question to the Precision Data Converters Forum.

Regards,
Ryan

0 Tom Hendrick over 10 years ago

TI__Guru**** 182821 points

Hi Rushin,

Assuming you use the hardware and GUI assocoated with the ADS1292ECG-FE, you can connect a function generator and see a sine wave on your PC.

0 Rushin Thakkar over 10 years ago in reply to Tom Hendrick

Expert 1285 points

ok thanks for your support. do we have to write some source code??.
(1) in hardware what is required ?? kit or some other thing
(2) how much input it can take?? and how much frequency we can give it??

0 Tom Hendrick over 10 years ago in reply to Rushin Thakkar

TI__Guru**** 182821 points

Well...the best place to start would be to read the document associated with the ADS1292ECG-FE. That will give you details on the hardware and required PC installation details. For Q2, you can refer to the ADS1292 datasheet which describes the analog input limitations (voltage levels, bandwidth, etc) depending on the gain and OSR settings you configure the device with.

Data converters

Data converters forum

ads1192 development kit