ADS1298 EVM : Error loading the fiemware

muhammad ather

Hello,

I am trying to connect MMBO with my PC. When I connects , it gives found new hardware popup and Install drivers for MMB0 (NI-VISA). now when I start the software It gives an error "The firmware load has failed due to timeout condition.Please reset the hardware to continue loading the firmware"

I am resetting the board but it has no effect. How may I solve this issue ?

over 9 years ago

0 Joseph Wu over 9 years ago

TI__Guru* 97805 points

Muhammad,

I don't usually support this device, but could you please check this FAQ link for this EVM?

e2e.ti.com/.../1200

Please let us know if it helps (or if it doesn't help).

Joseph Wu

0 muhammad ather over 9 years ago in reply to Joseph Wu

Intellectual 310 points

I had already gone through this page.
I am not getting any prompt regarding Driver installation. First my MMB0 (NI-VISA) driver was installed successfully but USBStyx Driver was never prompted. I uninstalled my MMB0 driver and now I am neither getting MMB0 nor USBStyx Driver installation prompt.

0 muhammad ather over 9 years ago in reply to Joseph Wu

Intellectual 310 points

The problem was that my USBstyx drivers were not installed So I downloaded and installed them. And now problem my has been resolved.

Data converters

Data converters forum

ADS1298 EVM : Error loading the fiemware