DAC900 after Power Down

Russell Wetherley1

Other Parts Discussed in Thread: THS5651A

Hello E2E,

I was looking through the DAC900TPWRQ1 data sheet on the website and maybe I'm missing it but I can't seem to find information on how much time should be given to the part after coming out of Power Down in order to be ready for operation. I don't want to assume it's instant but if you could inquire or let me know a rough time of how long we should wait to use the part after coming out of Power Down that would be greatly appreciated.

Thanks!

Russell

over 8 years ago

0 Jim Brinkhurst1 over 8 years ago

TI__Mastermind 44550 points

Hi Russell
Someone will look into this and respond as soon as possible.
Best regards,
Jim B

0 Russell Wetherley1 over 8 years ago in reply to Jim Brinkhurst1

TI__Expert 4255 points

Thank you Jim.
One other question on that DAC: The DAC has a PD that puts it in lower power consumption. From what I can see, VA is "shut off" going from 30mA to 2mA. Now my question is if we actually leave PD Low (The DAC is active) but take away the clock, would we see the same power savings?

Thanks!

Russell

0 jim s over 8 years ago in reply to Russell Wetherley1

TI__Guru* 91947 points

Russell,

When the clock is removed, the digital DVDD supply drops from 0.147A to 0.130A. The analog supply, VA+, does not change.

Regards,

Jim

0 Russell Wetherley1 over 8 years ago in reply to jim s

TI__Expert 4255 points

Thank you Jim. Any comment on the first question?

Russell

0 jim s over 8 years ago in reply to Russell Wetherley1

TI__Guru* 91947 points

Russell,

This is an old part that was done by Burr Brown many years ago. The original designers are no longer with TI and I am sorry to say we do not have answer for question 1.

Regards,

Jim

0 Russell Wetherley1 over 8 years ago in reply to jim s

TI__Expert 4255 points

Thank you Jim,

Is it possible to set up a test for this in order to give some sort of timing requirement? If not, is there is a drop in replacement or worst case, a total replacement for the parallel DAC, that actually specifies the "wake-up" time in the data sheet?

Thanks!

Russell

0 jim s over 8 years ago in reply to Russell Wetherley1

TI__Guru* 91947 points

Russell,

I will attempt to measure this. The THS5651A is a drop in replacement but only has a max sample rate of 100MHz. Per the data sheet, it awakes ~ 3ms after coming out of sleep mode.

Regards,

Jim

0 jim s over 8 years ago in reply to jim s

TI__Guru* 91947 points

Russell,

I measured the coming out of sleep mode and it appears to be around 170uS. See attached photo.

Regards,

Jim

0 Russell Wetherley1 over 8 years ago in reply to jim s

TI__Expert 4255 points

Fantastic!

Thank you Jim!

Russell

Data converters

Data converters forum

DAC900 after Power Down