DAC5672A Latency clarification

Edward Watts19

Intellectual 930 points

Other Parts Discussed in Thread: DAC5672A

Hello Team,

I have a customer asking about the latency specifications in the datasheet on page 7 Switching Characteristics;

Is this specification correct and the Min and Max is 4 clock pulses for both modes?

Thank you for your time.

Regards,

Ed Watts

over 8 years ago

0 jim s over 8 years ago

TI__Guru* 91947 points

Ed,

We are looking into this.

Regards,

Jim

0 Edward Watts19 over 8 years ago in reply to jim s

TI__Intellectual 930 points

Tim,

Thank you, I look forward to y'alls reply.

Regards,

Ed

0 Neeraj Gill over 8 years ago in reply to Edward Watts19

TI__Mastermind 20541 points

Hi Edward,

Yes, the timing number in the datasheet should be correct. And the four clock latency number should be used as a typical value rather than min or max.

Regards,

Neeraj Gill

0 Edward Watts19 over 8 years ago in reply to Neeraj Gill

TI__Intellectual 930 points

Hello Neeraj,

Thank you for that information. I will relay it to our customer.

Have a great day!

Regards,
Ed Watts

Data converters

Data converters forum

DAC5672A Latency clarification